The voltage is 35 KV, the capacity of the distribution transformer SC (H) B 10 is 100 -3150 KVA, and that of the power transformer SC (H) 10 is 800-25000 KVA. The new generation H Grade insulation transformer is developed on the basis of the advanced technology; both of the design and the production process are fully in accordance with the standard of IEC60076, GB6450 and GB/T10228. And therefore this type of transformer is widely used in the places such as electric plants, power plants, industrial and mining ...
Safety, flame-retardant, free of pollution and can go deep into the load center.
Free of maintenance, easy installation and low general running cost.
Good ability of humidity resistance and it can run normally under 100% humidity, and can go to the running without pre-drying after operation.
It has the features of Low loss, low partial discharge, low noise, and good ability of ...
This type of transformer can go deep into the load center, and has the features of flame-retardant, explosion-proof, free from pollution. It applies the epoxy casting mode and therefore has high mechanical property, and strong withstand of short-circuit, running safely, low loss, efficient power-saving. The loss is 40% lower than that of the three-phase dry-type power transformer which has the same capacity, low noise, small size and easy ...
This type of transformer is small, light, high insulation level (C-class), good ability of overload, low loss, low noise, flame-retardant, safe, environmental protection. And its performance has reached the first level of the nation.
This series product has the features of small size, light, safety and reliable, high insulation level, good overload ability, environmental-protection and low loss. All its performance has reached the first level in the nation...
The product has the features of small size, light, safety, high insulation level, good ability of overload and environmental protection. The no-load loss and the load loss is even lower than the epoxy series of products. It makes the promise that it can overload 20% without the cooling system and it truly reflects the advantages and highlights of the SG10 series products...
The core applies the high-quality of magnetic conductive silicon steel sheet, the no-load is low, and the surface of the core coated with the H-class resin insulation, and thus has the features of moisture-resistant, rust-proof. The insulation system of the coil applies the NOMEX® of the DuPont Company, and then impregnated by the solvent-free through the vacuum pressure, and then cured by the high temperature and therefore has high ...
The core applies the high-quality of magnetic conductive silicon steel sheet, the no-load is low, and the surface of the core coated with the H-class resin insulation, and thus has the features of moisture-resistant, rust-proof. The insulation system of the coil applies the NOMEX® of the DuPont Company, and then impregnated by the solvent-free through the vacuum pressure, and then cured by the high temperature and therefore has high ...
SG 10 series transformer is the first class of certificated products that produced by the cooperation of CNEKE and the DuPont Company, and it is also the first product that experienced three special test-F1 level combustion test, F2 level environmental test, and the C2 level climate experiment (-45℃ climate experiment). It is also the first products that have been gained the certification of the UL of America. SG 10 products gained the honor ...
SCRB products is a new protection type of power transformer, it has good cooling system and does not need the model and is flexibly designed, and it has the good resistance of thermal shock; the transformer can be self-cleaning in the operation of more vertical of the airway. It is the lowest loss transformer by the Southeast University CNEKE transformer research and development center. The transformer is the new generation of moisture-proof, dust-proof, security and environmental protection concept of the impregnation of ....
The structure applies the combination of the solid (NOMEX+H-level vanish) insulation and the gas (air) insulation. The high-tension line applies the wrapping way and the low-tension line applies the high-quality copper foil. And therefore improves the adaptation to the environment of the NOMEX insulation dry-type transformer, especially suitable for the hydropower plants, electric plants, steel, chemicals, mines where are high temperature, high humidity, high filthy...
Amorphous alloy is the rapid solidification alloy that appropriate composition of the liquid metal cooling itself about 1 million degrees Celsius per second. It has the features of the similar glass alloy of non-crystalline atomic structure and soft nature for its atomic has been solid before the coagulation...
This series is the new type products that produced based on the SG10 H class insulation open ventilation dry-type transformer and the advanced technology of America. It has good performance and therefore greatly reduces the no-load loss, and the load-loss. It is the most advanced transformer at the present. It has the features of safety, reliable, energy-saving and can go deep into the load center. It is especially suitable for the development of the modern society....
As for the 220KV power grid capacity, the effect of the negative harmonic sequence caused by the 220KV single phase traction and to the 220KV power grid is very small. The power supply system of the 220KV is more reliable and stable. The single phase electricity supply is more in line with the characteristics of that of the railway station. That is, easy protection, small investment, and effectively reduces the operating cost....
This series of products have the features of low loss, low noise, low partial discharge and low temperature fluctuant and hanging-free and no leakage. The state transformer quality supervision and inspection center shows that all the performance of the transformer has meet the 10 type standards of JB/T3837-2003 after series testing...
Furnace transformer means the industrial smelting power transformer; it is produced on the basis of overload characteristics of running features of the furnace transformer. It mainly includes the electric arc furnace transformer, ladle refining furnace transformer, electro slag furnace transformer, and submerged ac furnace (ferroalloy furnace, calcium carbide furnace, phosphorus furnace, etc.) transformers, power frequency induction furnace transformers, and other exchanges furnace transformer...
110KV series power transformer is the new type of products that produced on the basis of the new advanced technology. It has the features of low loss, low noise, strong ability of withstanding short-circuit, and running safely. There are four types as following:
1. S10, SF10 series of two-non-excited winding surge of cold (or air-cooled) low noise transformer series: 6300-120000KVA, linked in the three-phase non-excited-load switch, the operation is synchronous and can be operated on the top or the lower part. The company can produce the products according to the special requirements of the users...
This series of product is based on the production of SC9 dry-type transformer and S9 series oil-immerse transformer and the SG10 open ventilation dry type power transformer and the advanced technology from abroad. The products applies the combination of the NOMEX® material and the high burning oil, and then through several times of impregnation of the H-class solvent-free varnish technology to improve the thermal standing and the mechanical property.
....
Underground transformer is a new type transformer that independently developed on the basis of the combination of the advanced technology from abroad and the actual situation of china. It is the true meaning of underground transformer for it can be installed underground and does not occupy any space, and can run safely in water for a certain period time. And it is maintenance-free...